FPV pre-flight and build checklists
Tick them off on your phone at the field, or print them for the bench.
Before every flight 0/11
- Wind and rain are within what your quad handles. Can I fly today
- The spot is in a green zone on the airspace map, and you have the landowner's OK. Drone rules in India
- No people, animals or cars in the flying area or under your flight path.
- Props are tight, undamaged and on the right motors for their direction.
- Frame, arms and screws are tight; no cracked arms.
- Battery is charged, not puffed, and strapped down firmly. LiPo voltages
- Antennas are clear of the props and pointed the right way.
- Your video channel is clear of everyone else's. Channel planner
- Radio is on, on the right model, with the arm switch off before plugging in.
- Failsafe tested recently: turning the radio off drops the quad, it doesn't fly away.
- Goggles on the right channel and recording, if you want the footage.
Finishing a new build 0/13
- First power-up through a smoke stopper, props off.
- Checked for shorts between the battery pads with a multimeter before plugging in.
- Motor order and direction checked in Betaflight's Motors tab (props off).
- Props match motor direction (props in or props out).
- Board orientation is right: the 3D model in Betaflight moves with the quad.
- Receiver bound, channel map right, every stick and switch moving the right way. Controller tester
- Failsafe set and tested.
- Arm switch on a switch, with a beeper or turtle mode if you want them.
- VTX table loaded, channel and power set, antenna attached before powering the VTX.
- OSD shows battery voltage, mAh used, flight timer and link quality.
- Rates set to what you fly in the sim. Rates calculator
- Saved a diff all backup of the finished setup.
- First hover low and close, over grass, before anything else.
Questions
- What should I check before an FPV flight?
- Weather and airspace, that the area is clear of people, props and frame, battery health and strap, antennas, your video channel, the radio and arm switch, and that failsafe works.
- Why use a smoke stopper on a new build?
- It limits current on the first power-up, so a short or a bad solder joint makes it glow instead of burning your flight controller or ESC.
- Are my ticks saved?
- Yes, in this browser only. Nothing is sent to FPV Grind.
Free, in your browser
Fly it before you fly it for real
The FPV Grind sim runs in the browser with a gamepad, a radio or the keyboard. No download, no account.
Open the simMore free tools
- ELRS packet ratesEvery ExpressLRS 4.x and 3.x packet rate with its sensitivity, and a range estimate from power and antennas.
- Betaflight diffPaste diff all to see every changed setting explained, with warnings, or compare two diffs side by side.
- Arming flagsTick the arming disable flags Betaflight shows, or paste CLI status, to see what each means and how to fix it.
- Wiring helperWhich UART each add-on goes on, how to wire it, and the Betaflight Ports settings and CLI lines.
- Latency and FOVHDZero, DJI and Walksnail latency and goggle field of view, from each maker's own specs.
- FPV spotsPlaces to fly near you, added by pilots and groups, and the groups that fly them.